Thor Forums

Thor Forums (https://www.thorforums.com/forums/)
-   Motorhome Tech Topics (https://www.thorforums.com/forums/f10/)
-   -   Lippert Slide Controller (https://www.thorforums.com/forums/f10/lippert-slide-controller-17964.html)

jbwilli1 06-27-2019 03:56 AM

Lippert Slide Controller
 
1 Attachment(s)
I'm getting one green & nine red blinks, hall power short to ground.


Anyone know what this is & how to fix/reset? All slides working OK.


Thanx

16ACE27 06-27-2019 03:59 AM

If the slides work OK stop looking at the lights. Even when you have a problem, the light code can be very suspect.

Beau388 06-27-2019 04:55 AM

Quote:

Originally Posted by jbwilli1 (Post 189907)
I'm getting one green & nine red blinks, hall power short to ground.
Anyone know what this is & how to fix/reset? All slides working OK.
Thanx

With that fault - hall power short to ground - the slide will move about 2 inches and then stop showing that code. It can be overridden by pressing the button in the controller seven times then holding the button down for about 6 seconds. There is a power wire in the six wire bundle from controller that travels to the motor's hall effect sensor. There also a ground wire for the hall effect sensor and a communication wire that is used to keep the motors in-sync.
The brown wire in the bundle is the hall power wire and somewhere it is grounded to the frame, the hall ground wire or the motor ground wire. The fault is probably because of chaffing along the cable. The flash of green (one or two) will tell you which motor's cable has the short.



Here is the Tech's manual <https://lci-support-doc.s3.amazonaws.com/manuals/slideouts/ccd-0001769.pdf>

lug 06-28-2019 10:18 PM

My 2018 ACE 32.1 does the same thing after transit. Once I'm up on the Jack's I hit the retract button for each slide to sync the motors again. I go out and do my hook ups, verify no flashing lights and go inside to run the slides out. It took me a few trips to figure out what was causing my problem.

revjeffrey 06-29-2019 12:57 AM

Big rule in our family....When technology is working.
Do Not Touch It !

Judge 06-29-2019 01:41 AM

See this that I posted today......

https://www.thorforums.com/forums/f10...ion-17986.html


All times are GMT. The time now is 02:35 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0 PL2