FW28z - my CNC is a home-built 3-axis
MOMUS. Capacity is roughly 15 x 15 x 3. I drive it with Mach3 software and a Gecko 540 controller. Cost to complete was about $1500. I use it primarily to make RC airplane parts, but it has other uses as well.
Larry, thanks. My rates really aren't that bad, but I'm slooooooow. A bigger problem doing custom work for RV's is that nothing is actually standard; everything has to be designed & built for each specific coach.
That said, I could do up a bunch of the counter-extension stops at a reasonable price if folks would like them.
No luck with the thieves...
Regards,
Randy