Hi again, well now I had to check out my 2013 ACE 30.1 Pantry again. I used the suction cup technique another poster suggested to lift up the lower pantry shelf and flip it on its side. This revealed four screws (can use a phillips or red robertson on them......they are tough to remove and re-install so I suggest a robertson - square drive). Once the screws are all out the Pantry upper unit will slide off the lower pantry track unit which has a wooden covering over the metal rail system. Reinstall taking care to try to get the 4 screws back into the same holes on the slider base. It might be worth marking where the pantry upper unit is in relation to the slide base before taking the screws out so you can get them back into the same position (as best as possible). Also I noted that when I ran wiring for my inverter I could not run it through the pantry track at the wall so I just looped it up and over......no issues closing the pantry doing so. I am attaching a few pictures and hopefully they help someone else. Note the blood on some shots.....damn mini staples were still in the bare wood runners from when Thor stapled down the thin shelf base.
Thor Forums
