Thor Forums

[jdharrington]

Originally Posted by cobrasp58

Taking the cowl off was very easy, just four screws hold it in. Once off I removed the original insulation carefully so I could use it later. I cleaned the underside of the cowl and form fitted the Dynamat onto it, the stuff is pretty sticky, so be careful, its not very thick but does a great job. I used dynamat tape to seal the edges and seams, then I installed the original insulation and used more dynamat tape to seal that. After I completed that I had enough left over to do the underside beneath the driver and passenger seats. Made a substantial noise reduction.

Thank you!