Quote:
Originally Posted by halfprice
Sounds like you need to do a reset to calibrate level. Sorry dont know how to do this but many people have posted the steps
I just go by the four lights on my monitor and follow this procedure.
1. Lower rear jacks until I feel them hit the ground
2. Lower front jacks until I feel them hit the ground
3 Lower right side until I feel it hit
4 Lower left side until feel it hit
Left and right will most likely already be on the ground. So I lower then til they move the mh Usually only a quick tap of the button
5 Raise which ever side is lower by what the monitor says. Little at a time until the red light on the low side goes to green in the middle indicating level.
6 Raise the front and right side a hair to allow the ac condensation to run toward the left back of the mh.
7 Check level with the app I have on my cell phone
This only takes a minute or so to do
On the last couple of trips it felt like the mh was low to the front. SO this last trip I took out the level and checked several different spots on the floor, kitchen counter, and stove top. All level
Jerry
|
Thank you for sharing the information.
Also The Gritz Carlton.
Thor Forums
