Did some minor work on the mh yesterday
1. Reconnect wires in Gen junction box. Used these connectors for the wiring
Morris Products 97102 Insulated...
https://www.amazon.com/dp/B005FMQ5BQ?ref=yo_pop_ma_swf
Found one wire insulation was cut at the outer Romex insulation. Luckily there was excess wire under the bed going to the transfer box. Was able to pull it to the junction box.
2. Rewired water heater. Found several loose wire nuts and all wire nuts taped together not individually
The wires leading to the outside control panel were just hanging down. So I put them in an electrical box that I screwed to the back wall
3. Checked all wires going into the breaker box. Several srcews holding the wires to the terminals were loose all tightened
4. Made ramps to drive onto. The front end sits 4-1/2" lower do to slope in driveway. Use 3/4 plywood, screwed and glued
So hopefully with the wiribg done there shouldn't he any arcing of any wires
Only pic I took was of the cut insulation. I post a pic of the ramp later
Jerry