Quote:
Originally Posted by halfprice
What wire did you tie into for power
Jerry
|
I tied directly into the power (pink) wire for the Grey water heater switch back side of power panel. One thing I did do differently than Tom, I fixed a 6 foot piece of fishing braid to a stiff solid core wire and pushed it through the lighting wire feed hole in the ceiling inside/top power panel and pushed the braid though the square conduit from that direction to the new 1/2" hole drilled at the vent housing. Grabbed the braid there, tied the other end braid to the new wires for fan power and pulled them easily through without a problem. Doing it reversed would be a challenge as the hole is tuff to get eyes on if you only remove the power board for access and not the cabinet walls.
Roger . . . I'm always up for a fishing trip!