manual slide retraction
I just picked up my SR yesterday and had the tech walk through the procedure. Upper corner each slide is a set screw. Remove that to allow access to the motor. Use a flat blade screwdriver to pry the motor up and out. disconnect the motor - may have to go inside behind the seal to unplug. Do this in both upper corners. Then, with some help, and being careful to keep the slide even, push it back into the wall. Then replace the motor, the same way it came out, to lock the slide back in place.
I seriously hope I never have to do this, but these are the directions I was given. Thought I'd share in case that is any help.
__________________
|