Quote:
Originally Posted by Steve70605
I had the same issue with mine. The microwave was installed as it comes from the factory (i.e the vent shield was left in the interior vent position as a factory default). You have to remove the microwave ant swap the vent flap. Not a big issue if you have ever installed a residential microwave in your home. Not all Thor products had exterior vents. Should have been caught by installer.
Hope this helps....
|
Steve,
Never installed a microwave before. Our home unit is on a microwave cart with wheels.
How many screws hold it in place? I see four screws along the back edge, going upwards, probably into a mounting board.
Do you have to remove the door and fascia from the oven to access bigger screws that hold it to the cabinets on either side? I don't see any screws on the right side, just a narrow open space.
Is it hung from a support bracket above? Does it slide into place on such a bracket?
See photographs of my installation ...
Perhaps I should take another look at the installation manual 😉