I bent one of my pads while trying to put a couple of boards under it while leveling on soft ground. The softness of the ground was uneven and half the pad went into the ground and spit the board out. I got a replacement from Lippert. I measured the diameter of the old pad and gave them the part number of the hydraulic cylinder. The one I got had slightly different stamping, but the diameter and mounting hole size were right.
I have Snap Pads and have been quite happy with them. Install was simple - just a little soapy water on the pad interior and then lowering the leveler into the Snap Pad. Main challenge was making sure the Snap Pad was directly under the leveler pad. I lowered the levelers until they a little more than an inch off the ground and position the Snap Pad.
__________________
Rick
2017 Thor ACE 30.1
2017 Jeep Cherokee Trailhawk
Roadmaster Falcon All Terrain
RVi Brake 3
|