the new theater seat gets installed
So I worked through the dilemma of the hole in the slide floor.
Removed that burlap velcro cover. (see pic)
Covered the majority of it with 16 gauge sheet metal to provide more support under the front seat unit feet. I left a cutout for the 2 wires and hose.
Without it one side of the feet would be over the hole and not supported. Attached with about 1/2 inch screws.
Removed the window vertical shade pieces since they get in the way of the back section reclining.
Assembled the three sections, slid the backs on and test fitted operations. Good to go.
Still need to install the brackets for frame to floor. and install the outside slide floor sheet metal cover plate (when it warms up a bit.
Gary
__________________
|