Quote:
Originally Posted by Kona Tom
My Clovis Pin was bent and steps would not open well. I was able to remove the Clevis pin and carter pin. Motor is working freely and I have a new clevis pin. However, I cannot align the holes to reinsert the clevis pin. It’s off just slightly. I have tried open and closed setting but neither align. It’s closer when the door is open, but still not clear enough to insert pin. Any suggestions would be appreciated. Thank you.
2018 Windsport Thor. Electric Steps.
Kona Tom
|
Activate the step motor by opening the screen door. AS the gear arm moves disconnect the wiring harness at the gear box. This stops the gear arm midway. Now you can push the step in or out to allow the pin to line up to the gear arm
Its easier to disconnect the harness first then connect it to the point of contact, not completely attached. Sometimes the harness is a pain to disconnect
Good luck
Jerry