Quote:
Originally Posted by taylorbob1
Gently used tire and new rim are now mounted, and placed under the rear of my Vegas 24.1
Not yet securely supported, but I have the materials to finalize.
Will be using Channel Iron, placed from side to side and fastened to the frame
Note...
~ I had to reduce the air pressure to 20# so that it would fit between the trailer hitch and the floorboard. If spare is ever needed, I will use my on-board air compressor to re-inflate on-site
~ also I moved and secured the wire loom, temporarily moved the trailer light harness. Once tire/rim is secured, I’ll re-fasten the trailer light harness in its original place
Here are some photos of the placement...
|
Nice job, Bob! I hope I can do something like this, sooner rather than later.