Quote:
Originally Posted by groswald
Ours is really hard to start, but so far it always works, eventually. The procedure I've developed is
1. Prime until the lite comes on.
2. Crank it for 10 to 20 seconds. It won't start.
3. Prime again.
4. Let it sit for a minute or two.
5. Hit the start switch. It will usually start this time. If not, repeat steps 3 through 5. I've never had to do ot more than twice.
Why does it work? No clue!
Regards,
Randy
|
This works for us, too. And, like Bruce pointed out, it will not start or run if the gas is less than about 1/4.
Please report back when you figure it out!