Quote:
Originally Posted by halfprice
When you activate the turn signal does the whole screen go to that camera?? Then after the turn go back to the 4 screens??
I had that problem with turn signal also. Picture was not clear in full screen mode. My solution was to disable the wires, trigger wires, that activated the full screen
I see the left/right cameras just fine no need to see them in full screen mode to make a lane change
In my pic you can see I have the rear camera set to half screen. Left upper right corner and right lower right corner
I can see what's next to me all the time with a good picture. Didn't like the full screen view
Jerry
|
Disabling that trigger wire was one of the first things I did on my system. I could not stand the fact that the sound muted when I put a turn signal on and unfortunately, my model of Axxera HU has not been updated to fix that issue.
One of the reasons that I went with the bigger monitor was so I could easily keep track of all three cameras, but I actually discovered that the solo rear camera was SO incredibly clear and gives me such a good view of approaching traffic that I leave it on there pretty much full time. I might play with it a bit and see about reattaching the trigger wire, now that I am not plugged into the Axxera HU any more.