Quote:
Originally Posted by Cwray
I'm seriously considering replacing the cheap day-blinds in my 34J. But for the life of me, I can't figure out how to take the cornices that are over the blinds down. I can see the single screw at the bottom of the vertical cornices on each side of the blinds. But I can't see anything holding in the top. And out of all the things installed in the RV, the cornices seem uniquely well attached. Knowing the likelihood of small screws stripping out of the flimsy walls--I'm afraid to just undo the two bottom screws and then start pulling & twisting.
I'm sure a yank would just rip these things outta the walls. But I'd like to not damage anything and put them back after installing either a day/night set of blinds or shades.
|
They have L shaped brackets holding the lambrequin to the wall. Unscrewing the top (vertical) screws, allow you to lift up and remove the lambrequin; then you can get to the wall (horizontal) screws holding the L shaped brackets to the wall.