Quote:
Originally Posted by wingnut60
Duane, I and couple others have had trouble getting the main feed line to the valve to seal--the brass nipple is too short and the plastic nut bottoms out on the nipple base before a good seal is obtained. Just a heads-up for your install. I just used some thread seal on mine, others have replaced the bushing in the plastic fitting. Maybe your luck will be better than mine...
|
This is the panel supplied to me by DRV service (white panel). The outer panel is different then what is being used on the new builds and the ports are in different locations.
The part circled in green is a check valve in the pump supply line.
The red arrow points to a that is capped off on the factory panel.
The green arrow points to a port that the factory panel uses.
Somewhere along the line of replacement panels the water heater feed/supply lines have to be reversed.