Quote:
Originally Posted by dstankov
Not positive but it should not. There is a separate procedure for clearing the level points and entering the calibration mode.
What normally works for me when I get the low voltage error is to do the following.
Turn off the leveler control panel.
Shutoff the engine
Wait a minute
Start the engine
Wait a minute until the engine idles smoothly and the alternator enters its charging mode
Turn on the leveling system control panel.
My low voltage error normally occurs when I try turning on the levelers too soon after starting the engine and the alternator has not had the initial time to start charging the batteries.
|
Good info, thank you much.