Quote:
Originally Posted by brucev
......][..
2nd problem is the furnace. My louvers are in upside down and the seal around the access door leaks. The last time I found a marine stainless louver to cover the louvers and stop that leak and I thought I had the leak around the door fixed but yesterday it again leaked all over the PC board and when we turned on the furnace the water took out the PCB again.
Bruce
|
Furnace problem is a repair kit from Atwood. Mine was repaired under warranty in 2016.. It is not just the louvers, the new door has an interior rubber gasket, the exhaust is located lower so the exhaust tube runs uphill not down.Comes with a new frame because the door mounts with more screws. My contact may not be there but Atwood CS should be able to help.
Judy Schulz, Atwood Products.
574-266-4828
1. Door replacement should include a new-
Door Frame,
Door, (It has no louvers)
Exhaust plate and
exhaust tube.
There is a gasket on the inside the door to prevent water entry. (missing on my original installation) Use putty to mount the new frame.
Contact her if any questions on installation.
Hope this helps..