Thor Forums - View Single Post - I want to start a new thread about nothing, and let it run...
I try to keep my mods all in one thread. If I start a new thread it will have a link to this thread.
This is part numbers and pictures for the wheel wells.
They're pulled out of the 24.1 again while I work on extra battery placement and chassis battery move.
But
If you look in my thread on the last page or so someone else has installed the same fender wells. You can ask him for pictures.
I have in the mod pile:
200sqft of 1 inch refractory cloth(weighs about 90lbs.)
200sqft of double side aluminum foiled bubble wrap
64sqft of 2inch ridgid foil sided foam
64sqft of half inch foil side foam
2 cases of foam spray
About 120sqft of poly foam like the nice squishy white foam they pack electronics in.
A hundred feet of foam door seal.
A plastic pickup truck bedliner that will be whacked into a belly pan from the front fascia to about midtransmission.
If I put any of it on and it makes it worse I'll be OK with the slight labor involved.
Bellypans will be put on using 1/4-20 nutserts, so it'll come off quickly.
Other daily dose crap has been in my way so no mods lately.
I'm in a bad mode of:
In 20" of snow the new tire spun on the rim of the gator flattening it and wrapping the tire chain around the axle while a half mile from home requiring I take the tractor to get it dislodged from where it froze to the ground, drag a floor jack up to the house, make a tool to get the damn chain unwrapped, tire is cold and squished and won't seat, which doesn't matter much because it cut the valve stem also, so I'll build another tool.
Multiplied by 100 other bullshit 'build a tool and fifteen steps to even get started on the normally thee minute job' jobs. But the good news is we live on open range and a herd of cows came through yesterday and pulled up and ate about 500 tulips and crapped everywhere.
Thor Forums
