Extend it all the way (down or up) and hold the switch for an extra 4-5 seconds when it reaches the end. Then move it all the way the other way holding the switch for an extra 4-5 seconds at the end the other way. Do this for a few times and it should even out.
Once its even always hold the switch for that extra 4-5 seconds when either lowering or raising the bunk. (Holding the switch re-times the motors.)
If it stops completely and you need to reset the controller open up the false panel on the left of the cabinet above the sink--that is where the controller is.
We've used this procedure every time we raise or lower the bunk and, so far, it has worked every time.
|