Thor Forums

[powerboatr]

well DARN
but i buried my moms bounder once in freezing cold weather and after several hours managed to get the bus to the street




i see you have lot s of stuff to put under wheels


you need to make sure jacks are fully retracted.
then place the widest strongest pads under the rear jacks and do a manual extension of rear jack. it may press the pads deep, but the goal is to get the rear wheels at least high enough to slide wide pads under rear tires.
you may to retract jacks a few times and place more pads under them until the sinking stops

once you have tires on firm pads or what ever you have to get under them


then repeat up front and get all wheels on solid pads.


then lay out wide strong boards or pads in front o of rear drive wheels and make sure the jacks are back in the retracted setting and drive out, you may have to stop and reset boards unless you have 40 feet of pads and board
hint.... you may need a dedicated person to man the controls unless you plan on doing one heck of a clean up inside

we did this and it took forever, but saved the bus