Thor Forums

[EA37TS]

Originally Posted by novanoel

No worries. Having different perspective is always a good thing.

The dealer will warranty the work for a year. Also, I'm currently working on an extended service plan, exclusionary, to cover the entire rig. Anything installed by dealer will be covered.

Getting back the modification, I don't see how this modification can have an impact on any other part. Unless of course we assume that the slide on the 25.1 is different than the slide on the 24.1 - mechanically or otherwise. Are the slide motors different? Is the slide mechanism different? The slide in the 25.1 is the same slide on the 24.1. The only difference is the furniture and made a few inches here or there.

Also, what could possible go wrong with two wooden benches, cushions, and a table?

The seat belts...I'm assuming will be tied into the old bolts. However, I do have to verify this.

The point I was making is that behind the couch there could be electrical cables or plumbing lines that could be impacted by the installation. If they exist these may need to be rerouted because they would no longer be hidden and out of the way with the dinette installation.

I imagine the seat belts on your current configuration are the same as my Challenger's couch. They are all attached in a line against the back wall of the slide. The seat belts on a dinette will more than likely have to be perpendicular to the current installation.