Quote:
Originally Posted by Beau388
There are two Hall effect wires in the cable, signal and power. This fault normally only happens at three places - the connector at the motor, the connector at the controller and the cable itself. Water can cause this, metal shavings can cause this, a faulty Hall wheel or sensor in the motor or an actual worn place in the cable. So somewhere there is a short so that the Hall effect module is not working properly.
|
Thanks Beau388. Im just having a hard time understanding why it happens to both controllers and after resetting and leaving the Batt switch on i can run the slide and bunk without getting blinking lights until i shut the power off then back on. In my mind a short should not reset. Again thanks