Quote:
Originally Posted by mavens
OK, I have located the use/store switch. I want to plug it in and have the switch in the USE position. Is that correct? This will recharge the house batteries, correct?
|
This is where it gets complicated. The switch controls a remote latching relay. It uses power from the house batteries to position the relay.
If the last position of the relay was in the USE position, the batteries are connected to the DC buss and charger and will charge if plugged into SP.
If the last position of the relay was in the STORE position and the batteries are too dead to move the relay to the USE position, the batteries will be separated from the DC buss and charger and will NOT charge.
This is why I recommended checking for charging voltage at the batteries with a voltmeter if possible.
BTW, I deleted your other duplicate thread. You'll get all the help you can handle with just a single thread.