I thought about using the Eternalbond tape (like 3 inch wide) and stick it directly to the TPO roof starting at the AC drains to channel to each corner of the RV. Kinda like an X pattern.
So I would Fold tape in half in the middle (one inch) then have one inch sides stuck to the roof (hard to explain but it would be like a flat flap sticking up one inch from the roof). Then I would block off the front and rear cap doing the same thing (V shaped pattern but leaving about one inch spot on each corner for the water to drip down).
I have NOT done this yet.... just an idea.
While driving the water will go where it want to go but while parked and fairly level I would think it would control where it drips down at. Perhaps add a gutter at these four points on the 4 corners?
I will take pictures if I end up doing this idea.
__________________
2017 Axis / 25.4: Big Foot Levelers, Aims 1200 Watt inverter, Ceramic Window Tint, Full River AGM 6V batteries, Front Hellwig Sway bar / Rear Track Arm, Safe T Plus Steering Stabilizer, PD 4655 converter, Hard Wired Surge Guard, WEboost + WiFi Ranger, LED Headlights/Driving lights, TPMS, Surge tank, Tornado flush, Viair Compressor
|