|
The slide motors are all equipped with an electric motor brake. Any time the power center's 12 volt section has power, the motor's brake is applied. This requires a 3 to 4 amp draw through the 30 amp fuse. Activating the slide's controller deactivates the brakes. Considering there is a 350:1 or 500:1 gear reduction in the motor than is quit a bit of holding force. That said, the slide can gradually vibrate out a little if the road is rough.
__________________
Jim & Roy Davis
2016 Hurricane 31S
1961 Rampside in tow
|
Thor Forums
