Quote:
Originally Posted by MaceMan
My ACE 30.3 gas a door on each side of the bath area. The one in the bedroom came off, held by a few screws into the ceiling with nothing in the ceiling to screw into! I drilled pilot holes horizontally through the piece of wood at the top of the track and put long screws through to the frame member at the top of the wall. <clip>....
|
That may be the next option. for now I just put about 6 #10 wood screws through the track and its 1" backing-board into the ceiling panel. I did hit a frame on one end (and skiipped it) and may go back an put a screw there, but I don't see that I have a frame beside the Track for any horizontal attachment. It is outside the bathroom, and I could go into the bathroom wall and that would be more secure (in shear rather than tension). I did buy some ceramic magnets to find them and they are in weird places (to me)
Lots of dumb stuff left to get to. Nothing big, just stuff that isn't going to last or like your thermostat, likely to move and cause an issue. And sometimes you need to make a tool to avoid disassembling half the coach. The barn door has a screw into the top track slider. it vibrated loose dropping the door. Got it reassembled with my fingers, but had to make a bent 3/8" end wrench to get it back up where it belongs. Will now put some wicking thread locker on it so it doesn't happen again.