Quote:
Originally Posted by Fulltimer50
Now that I finally have more time to start this maint project and found some questions. Since I got the oil seals you suggested, and since grease is such a mess I figure I may as well try the oil bath way. I hope the parts you listed are for the 8K Morryde hubs w/kodiak disk brakes. I hand fit a seal onto the spindle and it seems to fit very tight as in will not turn freely. I admit at this point I did not put oil on them yet, just the lube they came with which is a bit tacky. What oil is suggested for the hubs? Thanks.
|
The seals will be a snug fit on spindles. Use lube to install.
I prefer AMZ/OIL 75-90 Severe Gear. It comes in a nice squeeze bottle.
On level ground fill to bottom of fill hole.