Quote:
Originally Posted by rbykid
Yes it has three camera wires going in the splitter box and one going out to the Axxera. I moved the output cable to the new Eyoyo monitor and shows no signal. The Eyoyo is set for the correct input but I tried all the input setting but no signal.
The splitter box has 12 volt power. I had the motor running and tried transmission in reverse and also tried left and right turn signal. I also had the Axxera power on but the touch screen does not work. Same message, no signal to new monitor.
My best guess is splitter box is defective. Any advice will be appreciated.
|
Sounds like you have all the bases covered. I would just do two idiot checks:
1 - The switch box (not splitter) has to have power to feed to the cameras. You've verified it has 12 VDC power in. Did you verify the + an - are goint to the right inputs? Thor has been known to confuse polarities.
2 - Depending on the model switchbox it may have one (video) or two (video and audio) RCA out jacks. Are you sure the RCA cable is connected to the video out and not the audio out?
So if those idiot checks passed and you have verified not video out to the new monitor either with or without the turn signals activated then I would concur the switch box has a problem.