Quote:
Originally Posted by DavidEM
For a Thor, with its TPO roof, I would not rely on just adhesives to attach your solar panels. For fibeglass or aluminum roofs, yes.
But there is a layer of 1/8" or so plywood underneath the TPO that will hold reasonable loads with a wood screw. Macdaddy's Amazon reference above shows #8 or #10 self tapping sheet metal scews tha should work fine. As noted above you only need 3/4-1" length.
Do use a good blob of Dicor or similar sealant above and below the screws.
David
|
I located the rafters with a stud finder, predrilled for the screws, injected Dicor into the holes, puddled a good bit of the stuff to bed the brackets and then flooded the brackets and screws when everything was in place. Super strong and zero risk of a leak.