Quote:
Originally Posted by standerson
Started the project of replacing the rear tail lights with LED's. First problem is there are 4 screws rusted off in the plywood. Thinking about going after them with a small bit on a rotary tool. Any better ideas?
Thanks.
|
Been there done that.
The easy way is to offstet the lens by a min. of .5 inches to the left or right and use ss screws. You can use compound to polish the gel coat to not have a color mismatch. Redrilling the holes is difficult and you have to refill some material. This assumes the plywood backing is good.
Thor Forums
