Quote:
Originally Posted by packrfan2001@yahoo.com
I have a 2018 Thor 29 mm Hurricane that the super slide only slides out 7in and stops I have checked the hydraulic oil and it is Midway on the dipstick not sure where to proceed from here I can retract the slide but it will only go out about 7 in. Is there some type of limit switch that may have stopped working?
|
The slide controller is in a basement compartment under the center of the slide. The slide controller will flash codes for the slide error. Here is the location of your slide manual which was included in your Thor manuals black bag.
1-8 Error codes
During operation when an error occurs the board will use the led’s to indicate where the problem exists.
For motor specific faults the green led will blink 1 time for motor 1, and 2 times for motor 2. The red led will blink from 2 to 9 times depending on the error code.
The error codes are as follows:
2 Battery drop out: Battery capacity low enough to drop below 6 volts while running
3 Low battery: Voltage below 8 volts at start of cycle
4 High battery: Voltage greater than 18 volts
5 Excessive motor current: High amperage, also indicated by 1 side of slide continually stalling.
6 Motor short circuit: Motor or wiring to motor has shorted out.
8 Hall signal not present: Encoder is not providing a signal. Usually a wiring problem.
9 Hall power short to ground: Power to encoder has been shorted to ground. Usually a wiring
problem.
When an error code is present, the board needs to be reset. Energizing the extend/retract switch resets the board. Energize the extend/retract switch again for normal operation.
Your slide it totally electric 12 volt Schwintek in-wall triple track. More info including the trouble shooting guide is available on line at <https://support.lci1.com/>