Quote:
Originally Posted by keefd
I did verify that the house/chassis batteries are going to the correct terminals as per Precision's documentation. That's not the problem (I hope). Have not yet checked the ignition and signal wires.
BTW, can anyone recommend an inexpensive in or on dash volatage monitor that can show both house and chassis batteries at the same time? My GPS/speed monitor shows the house voltage, but not chassis.
|
Forget the documentation.....
The chassis battery needs to go to the BATT-A post and the house batteries need to go to the BATT-B post.
Then be sure the Emergency Start Switch goes to the SIG post. That leaves the IGN wite above the BATT-A post and the chassis battery.
Thor Forums
