Quote:
Originally Posted by Snks
So the very thin plywood that boxes in to make the upper wall vent looks a bit just thrown together.
There also appears to be a temperature sensor in the upper area of the fins. I wonder if the plywood is cut too high or to low it is also fairly close to the fins. Can anyone confirm if this looks correct or have a picture of their side vent fridge to compare.
If the plywood is cut too high wouldn’t that cause a potential to overheat and the temperature sensor also shown in the pics shut the fridge down while on propane.
I’m not sure why the pics are sideways.
Thanks, Steve
|
If it doesn't overheat on AC it won't overheat on propane. The same heat is required to make the fridge work, the only difference is the source of the heat.