Quote:
Originally Posted by WearyTraveler
My setup is, from spigot out is:
Spigot - Y splitter - short water hose - water filters - pressure regulator - long zero G - wet bay
I put the regulator after the filters as I believe that each filter's resistance lowers the pressure so putting it before would lower the pressure too much.
Should I put the longer water hose before or after (which would allow only filtered water into the longer water rated hose) the filters?
I'm also considering getting a Berkey travel just for sihts and grins and drinking water. But that has nothing to do with my sequence question...
Thoughts?
|
Check your filter - most are only good for household pressures of 50-60 psi. If you put the regulator right at the spigot then you protect everything downstream. If you are worried about the filter causing a loss adjust the output on the regulator to accommodate.