Quote:
Originally Posted by ptnormd1
Hi all, I'm a new owner and wanted to insulate the doghouse/transmission engine cover on our new RV, a 2015 Thor Vegas. I can remove all the small screws but the 2 larger screws going down into the floor won't come all the way out. I got one out on the Passenger side but I can only get the Drivers side screw up about an inch and then it just turns and slides around. Not sure what I am doing wrong and I can't get a hand in there to figure it out. Anyone out there who has had a similar problem?
|
We have a 2016 Axis .. Ron had the doghouse off .. he sez on the bottom side of the floor those 2 large bolts go through a nut attached to a clip attached to the floor panel...he sez that clip might be spinning...vice-grips on the bottom nut may make it a one person job ... usually, he has me hold one end of whatever he is working on (with the appropriate tool) and he does the other.
We hope this helps !