Quote:
Originally Posted by 16ACE27
You will need the output from BOTH breakers to connect to you receptacle and get the full 5500 watts available. If your pool pump/heater run on 240 volts this will not work as the 5500 does not provide 240 VAC out, just two lines of 120 VAC, in phase.
|
Is the output of both breakers 4 wires total ( Ground, Neutral, Black & Red)?
and would I have to put the junction box in between the breakers and Automatic Transfer Switch?
I never even thought about the pool being 240vac? I am traveling now in RV so I can't check, what I recall though is that it is on a 20 amp breaker, and I don't think it was double pole? I may have to google my pool equipment to find out.
I have the power cords ready to go, just have to find a way to install the female l14 - 30R in the RV. If I can avoid doing anything inside the ATS, I may be able to do myself, but I may have a dealer do this for me.
If I can do this it will be the easiest way yet to put more hours on genny