|
My full wall slide was a little off. When I brought it in, it would stop because it looked like it was binding. I measured where it stopped and the front was 1.75 inches further in than the rear. I called their support and was given the following advice (which worked perfect in my case). They said to re-sync the motors, you have to run it in and out a minimum of 7 times. While this took a few times to get it making's way all the way in, once it did, I ran it about 10 times all the way in and then out. By the 7th time, I could see that the front and rear were moving at the same rate and landing at the same time. The motors work off of revolutions to keep in sync. Although I already knew this from my last motorhome, you should hold the switch another 3-5 seconds once the wall reaches the full extend or full retract position and/or until the motors stop moving completely. That's how they sync up. I found out with mine, my DW kept hitting the wrong switches and would slightly move the slide, then switch it the other way again and this messed up the timing.
Hope this helps.
__________________
2017 Thor Challenger 37LX, Westward interior, Riverside paint job. Upgraded to 4 battery setup, Splendide 2100XC Washer/Dryer combo, Progressive Industries HW50 EMS, Heavy Duty Steering stabilizer, and TST TPMS 6+4 setup for tow vehicle . Member FMCA
|
Thor Forums
