Hey all, we've seen so many great posts about sewer hose holding options, we finally took the time to engineer another option.
Using 4" pvc pipe from the local hardware store we constructed our new holder. The pipe starts inside the box containing the "dump" stuff. It exits this box through a new hole we cut in the back of the box, then elbows towards the back of the rv and runs along the frame of the chassis. Small holes drilled in the tubing to allow for drip. Both end have threaded caps to allow us to access a primary and secondary hose. Inside of the threaded cap we had to Dremel some pvc to allow for the hose "hooks" to go all the way in to the pvc so we could screw the cap back on.
Hardest part was putting on the hangers to hold it to the frame.
The pipe doesn't hang any lower than the storage boxes of the RV and we really like having access to the hose in from the dump box!
I think we'll add some fire foam insulation around the hole in the back of the box to help close it off a little better.
__________________
|