It was the circuit breaker. I also found out what blew the circuit breaker. Because my leveler wouldn't go back up. Sounded like hydrolic pump was not creating pressure. After a mobile service call and 200 bucks later and when being on the phone with lippert prior to the service call which they could have told me how to retract them but did not Grrrrrr. In there is z manufacturing problem with the wire harness. It has a box in the wiring which I believe is diodes.. They sent me out a new harness free of charge. But if you are one of the lucky ones that this happens to. Where the levelers won't go up look for the black and white wires. They connect to a solenoid on the left side of leveling system . A little hard to get too. Just disconnect the wire and they will go up. Then get a new harness from lippert.. If you want the levelers to go back down just reconnect the wire.. The new harness removes the diode pack. If I compared it to the old harness, there are only two wires rerouted. If I paid attention when I put the new one in. I could have Seen which wires to splice in in place of the diode pack..
__________________
|