1) One set of switches are in the same locations as the original pull controls and the other two are in the utility cabinet under the entrance closet. Each has a LED that indicates when a valve is not fully closed. All in all it took a full day.
2) Q - Were you able to do this by just removing the valve cover or did you have to remove more of the under belly cover?
A - The gray valve is accessible by removing the cover which was sealed on pretty good. The black valve is behind the water filter which I removed for access.
3) Q - Did the Drain Master valves replace just the center part of the existing valves or did you have to replace the entire valve assembly.
A - I wanted to leave the original valves installed ahead of the electric valves so I could use them as shut-offs in case the electric needed repair. It worked for the gray but not for the black. For the black I just replaced the original valve because there wasn't a good place to install the new valve. The new gray valve was installed down stream of the original valve. I just removed the original gray remote control and installed an extension that I can use to close the original gray valve from under the belly of the trailer.
This was done in 2010 and they have worked without any problems since. I did this mod on our previous Sunnybrook and will do it on the next RV if we ever buy again.
__________________
2007 MS 36 TK3, Demco Glide Ride
2012 GMC 3500HD D/A CC, AirSafe Hitch
|