The issue with the slide starts with the tracks. I started noticing the forward rails were showing signs of wear, I started finding small pieces of metal shavings on the floor behind the drivers seat. Then I started noticing as the slide would extend and retract, As it hit the mid point it would noticeably drop, while extending. While retracting, the motors would labor and it would not track evenly, the front would move a little, then the rear half would begrudgingly start to move. Sometimes it would just stop!! Wouldn't budge! I would have to extend it back out and start over again! How frustrating!!!!!
There have been times when it's taken 15 minutes to get the thing all the way in! As it retracts, it seems when it first starts it is pulling uphill, and when it finally hits the mid point, the whole slide kinda drops and lurches and seems to fall back into its tracks and will retract normally!
When the slide is fully in or fully extended, there doesn't appear to be any water leaks, so the seals are okay. I was looking at a washer and dryer, but I'm a little reluctant now, not sure what another couple hundred pounds on the slide would do to it!!
I've heard similar stories, and apperently a slide of this size and weight should have a total of six rails and motors, not four. So the four motors just aren't strong enough to move the ginormous slide!!!!
__________________
|