Yes we have the emergency start switch in the dash. In fact it is easily accessible below the radio. I doubt I'll wire into that. The connector on the back of the radio has both (see above discussion about B4 and B7) thus I'll likely just cut B7 and jumper that to B4 (either by crimping the two together, cutting both and then using a wire nut to tie them all together, or solder. I've successfully used wire nuts on car stereo's in the past--even on a 4x4 that went off-roading a lot--so I'm not worried about the wires coming apart). Thinking about it: The simplest way would be to cut both wires, strip 3 of the ends, wire-nut them together and finally wrap with electrical tape.
|