I recently had to remove the desk in our 2015 Windsport 27K to replace the blower motor.To remove the desk take out all the screws from the hinges and inside the tray. Next, pop off the trim cover from the 110v outlet, then loosen the two screws that work the wing/clips that hold the outlet in the hole. Once the outlet is free pull it into the tray, turn it 90 degrees, and push it back thru the hole it came out of. Now you can lift out the tray starting on the right side. Once the tray is moved a few inches you can unplug the wires from the 12v outlet.
When I removed our desk I found the ground wire was not attached. We don't use that outlet so we did not know it was not working.
__________________
|