Quote:
Originally Posted by yonnyb
A little help please!
I am looking at a 2015 24.2, I am a solo travler and would like to use the overhead bed full time. As such I would like to put a 6" mem foam matress there and leave it. I have looked at the sync problems listed here on the forum and I think I understand the issues. I would like some opinions to the following solution. moving the bed down about 4 inches and drilling a new pin locking hole in the track. that way I could move the bed up to the new pin hole and lock it in while driving thus taking the strain off the mechinism. when ready I would move the bed all they way to the bottom holding the switch for the recommended 2 secs to fully sync. any thoughts?
thanks Jon
|
I also wanted to put a decent mattress on the overhead bed. I also wanted to store the ladder up there as well. Here's what I did (
Thor Forums - View Single Post - Has anyone lowered the bed safty pins?)
I've been using this approach for a few months and it's worked with no problems. I haven't had any sync issues. I also no seen the bed slipping down at all even though I have the safety cables described in the link above in place just in case. Hope this helps.