Quote:
Originally Posted by Shawn62
I was getting ready to put my air compressor in a storage compartment similar to what dcbenny did. I was removing the gear in the compartment and noticed its floor was beginning to collapse. Inspection revealed they failed to secure the rear half of it. They were sparse in the front half in my opinion. I could see daylight so there goes the waterproof part also. Looks like I will be inspecting and securing the others tomorrow. Good old Thor quality control.
|
Just got done inspecting my storage compartment floors. Two of them only had 3 screws total. Overall screws were very sparse. I put in an additional 92 screws. I tried to space them every 6 to 8 inches. I also found about a dozen screws that secure the bottom trim pieces only about half screwed in. Good old Thor quality control.