There is a slide controller for each slide and the overhead bunk. They are identical. There are two multi-wire plugs (one for each motor) and two spade plugs with single wires for each controller - the spade lugs are the battery power supply to the controller.
The controller for the bunk is in the far left cabinet overs the dash, that will give you a idea of what you are looking for. Somewhere under the slide in a storage compartment is an identical slide controller mounted high on the compartment wall. There five wires in each multi-plug; two are for the hall-effect sensor. I suspect one has broken or pulled loose. The wires are clearly labeled in the controller.
If the slide will not move the emergency procedure is to override the controller (no synchronization). Press the override switch (just to the right of the LEDs on the controller) seven times in rapid succession holding in the seventh time until the lEDs flash rapidly. That will override all safety functions of the controller.
__________________
Jim & Roy Davis
2016 Hurricane 31S
1961 Rampside in tow
|