Quote:
Originally Posted by jb1911
Thanks a ton, just ordered one.
I'm a poet and don't know it.
|
Lol! Then vent comes in two pieces, a mounting ring with four holes for screws mounting, and the rotating vent which snaps in. Use the mounting ring as a template for drawing your cutout circle. Drill inside the hole with a 3/8" bit, then use a jigsaw to cut the hole out. I put painters tape on my jigsaw to keep from scratching the cover. Line up your mounting ring, mark the screw holes and drill for a #8 screw, use a panhead stainless screw 1/2 or 3/4" long.
Be sure you cut the hole in the exhaust end of the cover which is normally at the rear. Use the picture I posted as a reference.
Glad to help both of you and hope the mod works well for you!