If you read the Xantrex manual it states that if the inverter is connected to AC power there must be a breaker between the power source and the inverter (20A breaker for the XM1800). You can look at the inverter and see if there are wires going into the inverter on the AC input side as well as a wire connected to the AC Ground on the input side. If the AC input is wired then you may find a blown breaker some where close by.
__________________
Dave
US Army (Ret)
2020 Entegra Accolade 37TS
2019 Jeep Grand Cherokee Trailhawk (Toad)
FMCA - F432054
|